Why do toilet seats have such long screws? - toilet lid screws
Always stand at least 2 or more under the cut! Ok, I realize that I make the different sizes of balls, but probably not much difference?
My eyes are always free and no amount of tightening the screws in each time seems to be the case for a long time. Has anyone a solution (for printing only please!)
Friday, February 12, 2010
Toilet Lid Screws Why Do Toilet Seats Have Such Long Screws?
Subscribe to:
Post Comments (Atom)
Well, I've done hundreds of works of clothes (pays the bills, but disgusting), and that is my honest opinion on this application: After it managed to identify yourself, that there is a niche where nuts finally TOILET SEAT to close. If the screw is cut, it would be difficult, began the nuts on it - Hey! This is my gallery, give me a break. And stop laughing! - In the existing knowledge in the minds of the sanitary engineers has necessarily led to the conclusion that only a poor devil with his butt sticking out of jeans again, the nuts are installed on bolts, screws, and was on the front of the toilet seat closed circuit security, make contact, get the fruit began its journey upwards. Then hold the nut with one hectareª Giganto and a screwdriver with the other hand, it could be the turning point Boltho .... with one hand and still have their buttcrack visible, but warm and dry.
ReplyDeleteSuperglue? Give me a break!
Yes, I have Loctite Removable successfully. I saw the screws from the top down fall, if you want to ... but remember that "an" engineer "long screws, then 4 years college developed with a regular Joe Plumber Jane ..... right? LMAO
That's my story and I stayed with him.
I thought I was the only person who sees this problem.Thanks.You "put my mind at rest, I struggled with this problem for years absolutely stupid. (There is no problem-solving books!). I hope that this interest. Is this pathetic? !!!!!
ReplyDelete